Herringbone Wood Floor – The pattern consists of rows of parallel lines inclined, with each tilt encounter an inclination in the opposite direction, creating a chevron pattern. A wooden floor herringbone is a choice of elegant and sophisticated ground, suitable for a wide range of decorating styles.
Make sure the soil pattern herringbone wood floor works in the direction of the longest section of the room. Measure the room to determine the center point of the plant. Draw a chalk line along the ground to mark the center point. This will be the center of the pattern. Draw side on both sides of the center line, at a distance of 23.8 mm from the center line guidelines.
Adhesive to the center of the herringbone wood floor with a trowel Apply. Place the first Lama so that its upper left corner is placed in the guideline secondary to the left of the center guideline and the upper right corner of the bar is placed in the guideline secondary to the right of the center line. Measure the distance between the bar all last row and the wall. Cut the ribbon end of the row to the correct length.
Nail the first row of slats in place to ensure everyone is well established. Install the second row of ribbons to face the front row. Again, the upper left corner will be placed in the guideline secondary to the left of the center line and the top right of the secondary guideline to the right of the center. Continue to put rows of strips until the ground is covered. Check the alignment of the slats every four or five rows to ensure it is still flat. Wait 24 hours before relocating furniture in the new floor.